Are You Ready To Party??

If you’ve seen one, you’ve seen ‘em all, and our Dunk Tank is perfect for any event. The Dunk Tank is on a trailer and is easy to transport and sets up in less then 10 minutes.

Set Up:

1. If you are picking up the Dunk Tank, be sure you have a truck with a 2” ball, because that is what is on our trailer.
2. Select a level area for set up. Unhook the trailer and lights from the tow vehicle and roll it to the set up area. (NOTE: TRAILER AND TANK ARE 1 UNIT, DO NOT TRY TO SEPARATE!)
3. Raise the tongue end of the trailer and remove the hitch pins from the tongue bar. Slide the tongue bar out and replace the pins in the bar.
4. Slowly lift up from the open end of the tank to set the tank upright. Set the tongue bar behind the tank on the ground.
5. Untie the ropes holding the side canvas frame and swing it out into position. (NOTE: IT MAYBE NECESSARY TO BLOCK THE BOTTOM OF THE FRAME SO THE WIND DOES NOT MOVE IT AS THIS WILL CAUSE THE TARGET ARM TO BEND.)
6. Check the drain plug to make sure it is tight and then fill the tank to the top with water (NOTE: APPROX. 500 GALLONS.)
7. Install the red target disk and the target arm. Arm must be installed first, being careful to get flattened end through metal guide and between handles of vice grips. The other end of the arm is put through round metal guide and then through the hole in the canvas. Install the target to the end of the arm.
8. Test the target function by pushing against it. The seat should drop, if installed correctly. Raise the seat and close the vice grip located under the seat.
9. Enjoy your event with our Dunk Tank!

 {youtube}dyxnX4SAfbI{/youtube}

Are You Ready to Party??

4 Sanger Ave. Waterville, ME 04901

207-873-4944

www.areyoureadytoparty.net